|
Highlights from the full instruction
sheet that comes with every kit. For other questions, contact us or post in
The Wolf Miata Forum.
(Click images for larger view.)
When our engineers designed
power windows for the Miata 1, the goal was to make them as close in quality
to the Mazda original equipment as possible — and very easy to install.
We achieved this by using only the best-quality, tested products available from
around the world.
Our power window kits come with
full-color, detailed instructions showing, step-by-step, how to remove the door
panels and trims, install the parts and complete the wiring. There are no
holes to drill and no wires to cut. Everything fits to existing holes and
plugs into factory connectors. We're showing a few photos here to
give you some idea of how easy it really is.
 1. The
first job when fitting your car is to wire in the switches. When you take
out the blank switch panel from the center console, you'll find a six-pin
electrical connector attached to it. Simply plug in as shown in the
diagram and photos.
2. Connect the supplied wiring harness to the switches matching color to color.
 BROWN
WIRES TO GROUND
BLUE-BLACK WIRES TO DOOR, CONNECT TO MOTOR
RED-BLUE WIRES TO 12VOLT AND ACCESSORY LIVE
 3. Remove
the glass using the three 10mm head bolts “B” that hold the glass to the
mechanism. Remove the window stops “A” and then slide the glass upwards and out.
 4. Take
out the mechanism.
 5. Insert
the new mechanism. This is simply a reversal of the removal process for
the manual mechanism.
 6.
Bolt the mechanism in place. Refit the glass stops at “A” and “B”. Connect the
wires from the switch to the motor.
Test the operation of the windows.
|
>
